Ford Truck Enthusiasts, The Internet's Leading Ford Trucks Resource, F150
 
Articles
Ford Truck Enthusiasts 		Glossary   
Search  
   
Browse by Category
Articles
 Body, Bed, and Appearance
 Brake System
 Cooling System, Heating, and A/C
 Decoders, Codes, Charts, Etc.
 Diesel
 Electrical, Electronic, and Lighting
 Engine and Intake
 Exhaust
 Feature Articles, Reviews, and Misc.
 Fuel, Oil, and Air Systems
 Instrument Cluster and Dash Controls
 Interior
 New Products
 Roush F150 Project Truck
 Steering and Suspension
 Stories, Wit, and Humor
 Super Duty 6.0L King Ranch Project Truck
 Transmission / Axle
Articles .: Transmission / Axle .: T-18 Transmission Rebuild (Part 6)

T-18 Transmission Rebuild (Part 6)





Apply a thin coating of your favorite gasket sealer then the gasket and another layer of sealer.
 
Put the bearing cover on and tighten the bolts according to specs.
 
Do the same process for the pto cover plate.
 
Install the new teflon guides on the shifter forks, and clean the gasket sealing surfaces.
 
These are the small parts on the top of the tranny. I found that small pin at the bottom, of the tranny, so keep an eye on this one.
 
This is the small hole where that small pin goes.
 
Put the new seal in the extension housing using the correct tool.
 
Apply your sealer/gasket/sealer, put the top back on and bolt it down. When it sets-up all I'll have to do is paint the top and were done.
 

Page 1 - Page 2 - Page 3 - Page 4 - Page 5 - Page 6




How helpful was this article to you?

Related Articles

article T-18 Transmission Rebuild (Part 1)
  7-30-2004      
article T-18 Transmission Rebuild (Part 5)
  7-30-2004      
article T-18 Transmission Rebuild (Part 4)
  7-30-2004      
article T-18 Transmission Rebuild (Part 3)
  7-30-2004      

User Comments

Add Comment
No comments have been posted.


.: Powered by Lore 1.5.5
Ford-Trucks.com and Internet Brands, Inc. is not affiliated with the Ford Motor Company.
© 1997-2008 Internet Brands, Inc., Please see our Terms of Use / Privacy Policy